Garmin Performance Condition at Start

[kienzlem]

Hello,
hope you are all well.

Scenario: Garmin 945 with power meter on outdoor road bike. I see my performance condition (Start&End) in Runalyze. It works.

Now I have observed the following:

- Using my Garmin 945 with an indoor smart trainer (Wahoo Kickr Bike). I don't see Performance Condition in Runalyze at the start, only at the end. See the following figure (should be +5/0)

Runalyze_IndoorBike_issue.PNG (54.53 KiB) Viewed 288 times

In Garmin Connect I can see the start Performance Condition: (+5)

Garmin_Indoor_Bike_No_Issue_.PNG (1 MiB) Viewed 288 times

I took a look at the FIT file (FitRepairTool) and I see the Start and End Performance Conditions are in the FIT file.

I have now compared both files ( 1.) Road bike with power meter + 2.) Indoor Smart Trainer), the Start Performance Conditions are present in both about the same time (after 5-10 minutes).

Can you tell me what Runalzye is still missing to extract the Start Performance Condition in my Indoor Cycling mode?

Attached the Snapshot of Runalyze, Garmin and the FIT File.

Maybe the support can have a look?

Matthias

[mipapo]

We will take a look at it after christmas days. If there is a case where we miss that value we will fix it for all future activities.